 |
|||
|
|
|||
|
Page Title:
PRIMARY FUEL FILTER ASSEMBLY REMOVAL |
|
||
| ||||||||||
|
|
 TM 5-2410-233-23
PRIMARY FUEL FILTER ASSEMBLY MAINTENANCE - CONTINUED
0055 00
FILTER ELEMENT SERVICE - CONTINUED
7.
Inspect filter element (6) for dents, contamination or other damage. Replace if damaged.
8.
Place filter element (6) onto stud in filter case (2).
9.
Coat new gasket (5) with fuel and position onto filter case (2).
10.
Position filter case (2) onto filter base (4) and hand-tighten nut sleeve (3) until filter case is snug against filter base.
CAUTION
Do NOT overtighten or fuel leaks could result.
11.
Hold filter case (2) and wrench-tighten nut sleeve (3) an additional 3/4 turn.
12.
Turn fuel flow control valve (1) at bottom of fuel tank to ON.
13.
Prime fuel system (WP 0038 00).
14.
Check for any leaks by visually inspecting area.
PRIMARY FUEL FILTER ASSEMBLY REMOVAL
1.
Remove filter case and filter element. See Filter Element Service in this work package.
2.
Remove fuel priming pump (WP 0038 00).
3.
Disconnect fuel lines from filter base (WP 0050 00).
4.
Remove two capscrews (7), four washers (8) and two
7,8,9
10
11,12,13
nuts (9). Remove filter base (4) from support assembly
(10).
5.
If removal of support assembly (10) is required,
remove four capscrews (11), washers (12) and nuts
(13) that secure support assembly to muffler support
bracket.
386-303
11,12,13
0055 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals