 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
GOVERNOR CONTROLS AND LINKAGE MAINTENANCE - CONTINUED
0054 00
INSTALLATION
NOTE
Components shown are typical. There may be variations on your machine.
Use a rag to wipe contact surfaces of all moving parts clean prior to installation.
Drive small chisel into slot in lever to open it up for installation on shaft.
1.
If removed, install governor control lever (76) on governor with capscrew (78) and nut (77).
2.
Install jam nut (71) on lower end of governor control link (59).
3.
Connect lower end of governor control link (59) to clevis (75). Install clevis to governor control lever (76) with pin (74),
washer (73) and new cotter pin (72).
NOTE
If lever or component inside of a lever requires installation, drive small chisel into slot in lever to open it up
for installation.
4.
If removed, install key (69) and lever (66) on support (70) with capscrew (68) and nut (67).
5.
Connect governor control connector (65) to lever (66) with washer (64), plate (61), washer (63) and new cotter pin (62).
6.
Install spring (60) to plate (61) and to lower end of governor control link (59). Adjust IAW Adjustment at the end of this
work package.
7.
Install jam nuts (49 and 50) on rod (51).
8.
Connect lower end of rod (51) to clevis (58). Install clevis to governor control link (59) with pin (57), washer (56) and
new cotter pin (55).
9.
Connect upper end of rod (51) to ball joint (54). Install ball joint to bell crank (34) with new lockwasher (53) and nut
(52). Adjust IAW Adjustment at the end of this work package.
0054 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals