 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
FUEL LINES AND FITTINGS REPLACEMENT - CONTINUED
0050 00
REMOVAL
WARNING
DO NOT perform fuel system checks, inspections or maintenance while smoking or near fire, flames or
sparks. Fuel may ignite, causing injury or death, or equipment damage.
NOTE
When removing fuel shutoff valve or fuel drain valve, drain fuel tank completely (WP 0049
Use a suitable container to capture any fuel which may drain from lines. Dispose of fuel IAW
local policy and ordinances. Ensure all spills are cleaned up.
Fuel line routing and components shown are typical.
Tag lines to ensure correct installation if removing more than one line.
1.
Turn fuel shutoff valve (1) to OFF position.
1
386-417
2.
Remove three bolts (2), six washers (3), clamps (4) and three nuts (5).
3.
Remove three bolts (6), washers (7), small clips (8) and four large clips (9).
4.
Remove nut (10), washer (7) and two large clips (9).
CAUTION
Wipe area clean around all fuel connections to be opened during removal. Cap lines and plug openings after
removing lines. Contamination of fuel system could result in premature failure.
5.
Disconnect unions (11) from tube assemblies (12, 13 and 14).
6.
Disconnect tube assemblies (14 and 15) from elbows (16, 17 and 18).
7.
Disconnect elbows (16 and 17) from junction block assembly (19).
8.
Remove elbow (18) from primary filter base. Remove and discard O-ring (20).
9.
Disconnect tube assembly (12) from fitting (21).
10.
Remove fitting (21) from fuel flow control valve (1).
11.
Remove fuel shutoff valve (1) from elbow (22).
12.
Remove elbow (22) from fitting in bottom of fuel tank. Remove and discard O-ring (23).
0050 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals