 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
CRANKSHAFT PULLEY REPLACEMENT - CONTINUED
0026 00
CLEANING
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Failure to follow this warning may cause injury or death. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user must
wear protective goggles or face shield.
Clean removed parts with detergent. Dry parts with compressed air.
INSPECTION
1.
Inspect hub and crankshaft pulley for cracks or other damage. Replace if necessary.
2.
Inspect wear of pulley grooves. Measure distance that a new V-belt runs above or below top of each groove. If V-belt
runs more than 1/16 in. (1.6 mm) below top of groove, replace pulley.
3.
Refer to WP 0176 00 for additional inspection instructions.
INSTALLATION
1.
Apply coat of lubricating oil to exposed surface of crankshaft (5), front engine oil seal (9) and tapered surface inside hub
(4).
2.
Install hub (4) through crankshaft pulley (6) and secure with six washers (8) and bolts (7). Tighten bolts to 75 lb-ft (102
Nm).
3.
Install hub (4) and crankshaft pulley (6) to end of crankshaft (5).
NOTE
Position washer with large flat surface toward hub.
Position damper on hub so holes in damper are aligned with hub.
4.
Install adapter (3) and hub (4) to crankshaft end (5) with washer (2) and bolt (1). Tighten bolt to 230 lb-ft (312 Nm).
5.
Tap end of bolt with a hammer and again tighten bolt to 230 lb-ft (312 Nm).
5
6
9
4
3
2
1
7
8
386-021
0026 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals