 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
CRANKSHAFT FRONT SEAL AND WEAR PLATE REPLACEMENT - CONTINUED
0024 00
REMOVAL - CONTINUED
3.
Insert distorter ring (2) into seal bore.
2
386-190
4.
Place sleeve distorter (3) between distorter ring (2)
and wear sleeve (4). Turn until edge of distorter makes
3
4
a crease in wear sleeve. Make additional creases in
wear sleeve, every 90 degrees, then every 45 degrees,
until wear sleeve is loose. Remove distorter ring tool
and wear sleeve. Discard wear sleeve.
2
386-191
INSTALLATION
NOTE
Wear sleeve and crankshaft front seal must be installed together.
1.
Apply clean lubricating oil on seal lip of new seal (1) and on outside diameter of new wear sleeve (4).
2.
Install new seal (1) on new wear sleeve (4) as shown, with lip of seal towards side of wear sleeve that has chamfer on
inside diameter.
3.
Clean inside diameter of wear sleeve (4) and tapered surface of crankshaft (5) with quick cure primer coating.
4.
Apply sealing compound to surfaces on inside diameter of wear sleeve (4) and on crankshaft (5).
5.
Position wear sleeve (4) and seal (1) on crankshaft, with lip of seal towards engine.
0024 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals