 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
CYLINDER HEAD ASSEMBLY AND SPACER PLATE REPLACEMENT - CONTINUED
0023 00
REMOVAL - CONTINUED
6.
Remove six capscrews (16), 20 capscrews (17) and
washers (18) from cylinder head (19).
17
16
18
19
386-182
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Cylinder head weighs approximately 200 lb (91 kg).
7.
Install lifting links with 5/8 -11x 1-1/2 in. bolts or use
lifting bracket at front and rear of cylinder head.
8.
Attach a nylon sling and a suitable lifting equipment
to lifting points at front and rear of cylinder head (19).
CAUTION
Do not lower cylinder head onto a flat surface.
This could damage valves.
9.
Slowly and carefully lift cylinder head (19) from cyl-
19
inder block (20) and place it on a suitable stand or
platform which will support bottom perimeter of cyl-
inder head. Remove lifting links from cylinder head.
20
386-183
0023 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals