 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
VALVE MECHANISM MAINTENANCE - CONTINUED
0017 00
INSPECTION - CONTINUED
6.
Inspect push rods (10) for a bent condition, excessive wear or other damage. Replace a damaged or defective push rod.
7.
Inspect rocker shaft (8) for excessive wear, bent condition or other damage. Replace a damaged or defective rocker
shaft.
ASSEMBLY
CAUTION
Do NOT use old plugs, as worn or defective plugs could cause loss of oil pressure, resulting in damage to
engine.
1.
Install new plug (18) into each end of rocker shaft (8).
NOTE
Ensure hole in rear bracket is in alignment with hole in rocker shaft during installation.
2.
Install rear support bracket (5) and new pin (17) on rocker shaft (8). Pin must extend 0.378 in. (9.6 mm) above bracket.
NOTE
When installing one intake rocker arm in step 3, rocker arm is installed on outside of rear support
bracket (5).
Smaller rocker arms are intake and larger rocker arms are exhaust.
3.
Install intake rocker arm (16), washer (15), two spring tension washers (14) and retaining ring (13) on rear of rocker
shaft (8).
9
1
11
10
3
7
4
20
19
2
21
14
6
22
18
8
5
15
16
13
17
12
0017 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals