OPERATE BULLDOZER BLADE - CONTINUED

TM 5-2410-233-10

OPERATION UNDER USUAL CONDITIONS - CONTINUED

0005 00

OPERATE BULLDOZER BLADE - CONTINUED

WARNING

Do not allow machine to straddle tree trunk while tree is falling. Back away immediately when tree starts to

fall, to avoid injury, or damage to tractor.

(3) Ease into tree. Push in direction of fall with blade high. Build earth ramp if higher contact is needed.

Large Brush and Medium Size Tree Removal.

(1) Make contact with tree 12-16 in. (30.5-40.6 cm) above ground.

(2) Move forward while lifting blade.

Brush Clearing.

(1) Lower blade a few inches into the ground and move forward.

(2) Lift blade when brush is out, to loosen earth from roots.

Stump Removal.

(1) Depending on size of stump, cut roots as in Large Tree Removal.

(2) Contact stump near ground and lift blade while pushing.

m. Side Hill Cutting.

(1) Start cut downgrade if possible.

(2) Slope to inside of cut.

(3) Doze cut wide enough for bulldozers that will follow.

Rock or Boulder Removal.

(1) Tilt blade, place corner of blade under rock and work it up and down while pushing on rock.

(2) Disengage steering clutch on side opposite point of blade contact with rock.

0005 00-9