Installation - TM-10-3930-633-340163

TM 10-3930-633-34

between rack and sector teeth, assemble and

(8) Fill steering gear with recommended

lubricant in accordance with LO 10-3930-633-12.

tighten side cover bolts to 2535 ft/lbs.

f. Installation. Refer to Chapter 2, Section IV,

NOTE

Be careful not to damage seal when installing output

for details on installation of steering gear

shaft. Good practice would be to wrap output shaft

assembly.

serrations with plastic (electrician's) tape to prevent

g. Adjustment. Refer to TM 10-3930-633-12 for

cutting seal lip during shaft installation.

procedures covering thrust and lash adjustment

(7) Install output shaft adjuster screw

of the steering gear installed in the vehicle.

locknut on screw. Do not tighten at this time.

11-5