Installation and Adjustment - TM-10-3930-633-340047

TM 10-3930-633-34

(21 ) Install the rotor (2) and the distributor

diaphragm link to the movable breaker plate and

cap (1).

install the diaphragm retaining screws (14).

(22) Fill the oiler (31) with about 40 drops of

(19) Place the contact point assembly (18)

oil .

and the condenser (17) in position and install the

retaining screws (19, 20 and 21). Be sure to place

e. Installation and Adjustment. Refer to TM

10-3930-633-12 for procedures on installing the

the ground wire (16) under the condenser

retaining screws.

distributor, adjusting and aligning contact

points, and adjusting ignition timing.

(20) Connect the primary wire (22) and the

condenser lead to the contact point assembly.

3-13