Replacement - TM-10-3930-633-120076

TM 10-3930-633-12

misaligned hanger supports. These vibrations can

(2) Muffler. Disconnect the support bracket

and clamps (13) on each side of the muffler.

be eliminated by loosening the clamps and

Loosen the tail pipe support clamp bolt (1) and

changing position so that the exhaust pipe,

pull the tail pipe (6) down until it is free of the

muffler, and tail pipe will be in proper alignment,

muffler. Remove the muffler (15). To install the

free of contact with the frame or body.

muffler, reverse the above steps and properly

b. Replacement. Refer to figure 4-32 and

align the complete system, then tighten con-

proceed as outlined in the following paragraphs:

necting support brackets securely. Operate the

(1) Exhaust Pipe. Remove the nuts securing

engine and check for possible leaks.

the exhaust pipe (23) to the exhaust manifold.

Loosen and disconnect mounting clamp (19) as

(3) Tail Pipe. D i s c o n n e c t t h e s u p p o r t

necessary. Loosen clamp (14) securing exhaust

bracket and clamps (4) and (5) both at the rear of

pipe to muffler and remove exhaust pipe (23) and

the muffler and also at outlet end of the tail pipe

(6). Free the tail pipe from the muffler (15). To

(20).

assemble, position tail pipe to the muffler and

NOTE

Always use new gasket (24) between exhaust pipe

secure clamps, being careful to align the exhaust

(23) and exhaust manifold. After installation of

system so it doesn't contact body or frame. Check

exhaust pipe, check the exhaust system for

system for exhaust gas leaks.

alignment and leaks.

4-48