|
|
MWO 9-2320-287-35
NOTE
Installation of gladhand brackets and gladhands for right and
left side are the same. Left side shown.
W h e n marking the holes in steps A and B, extend the marks far
enough so that they cross each other.
a. Measure and mark 11 inches (27.9 cm) from top of headlight guard (1).
b.
Measure and mark 2 1/2 inches (6.4 cm) from the front of grill guard (2).
NOTE
It may be helpful to drill a 1/8 inch (3.18 mm) pilot hole before
drilling the 5/16 inch (7.9 mm) diameter hole.
c. Drill a 5/16 inch (7.9 mm) diameter hole (3) where the two marks on the grill
guard (2) cross each other.
F i g u r e 2. Drilling front gladhand bracket holes
6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |