 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 LO 9-2320-283-12
NOTES (CONTINUED)
pin and latch with a light oil. Perform this maintenance
Apply chassis grease (GAA) to lube fittings, weight
weekly.
adjuster, and slide rails at 12, 000 mile intervals.
14. ALTERNATOR.
18. OIL CAN POINTS.
Inspect unit at 24, 000 mile intervals. No lubrication is
Every 1, 000 miles or each month, whichever oc- curs
required. Bearings are factory sealed.
first, lubricate door, hood and side panel hinges, and
latches.
15. SLIDING FIFTH WHEEL.
19. FOR
OPERATION
OF
EQUIPMENT
IN
(a) Latch Mechanism - Apply a liberal amount of
PROTRACTED COLD TEMPERATURES BELOW -
GAA lubricant to the top and bottom latch
150F.
mechanisms every 1, 000 miles or each month,
whichever occurs first.
Remove lubricants prescribed in key for temperatures
above - 150F. Prelubricate with lubricants specified in
(b) Wheel Plate Surface - Apply a liberal amount of
key for temperatures below -150F. If OEA lubricant is
GAA lubricant to the wheel plate surface every 1,
required to meet the temperature ranges prescribed ;, ,
000 miles or each month, whichever occurs first.
the key, OEA lubricant is to be used in place of OEIHDO-
10 lubricant for all temperature ranges where OE/HDO-
(c) Sliding Fifth Wheel Bracket - Apply a film of
10 is specified in the key.
OE/HDO-10 lubricant on the rack and slide path of
the bracket on the sliding fifth wheel.
20. MILITARY SYMBOLS FOR LUBRICANTS.
16. TIRE HOIST WINCH.
The following references are lubrication symbols used
within this Lubrication Order to the appropriate
The following steps should be performed on a weekly
specification:
basis:
OE/HDO
Lubricating Oil, Internal Combustion Engine,
Tactical Service, MIL-L-21 04C
WARNING: Do not get oil or grease on the fiber
brake face or slippage resulting in personal
OEA
Lubricating Oil, Internal Combustion Engine,
injury could result.
Arctic, MIL-L-46167
(a) All gears should have a film of grease at all
GO
Lubricating Oil, Gear, Multipurpose, MIL-L-
times.
2105C
(b) The two bushings at both ends of the drum shaft,
GAA
Grease, Automotive and Artillery,
MIL-G-
the ratchet pawl, threads on the pinion shaft and the
10924C
steel handle disk should be wet with oil.
ATF
Fluid, Transmission (Dexron)
(c) Apply GAA to cable.
CW II
Lubricant, Chain, Exposed Gear, and Wire
17. DRIVER'S SEAT.
Rope, W-L-751 D
TA236744
CARD 18 of 19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals