NOTES (CONTUNUED) - LO-9-2320-283-120016

LO 9-2320-283-12

NOTES (CONTINUED)

Oil Pan - 9 Gallons

(3) Power Divider.

Fill power divider with 2

Bypass Oil Filter - .70 Gallon

pints.

Full-Flow Oil Filter - .93 Gallon

Also see note 12.

9. FRONT AND REAR SLACK ADJUSTERS AND

CAM LEVERS.

8. CRANKCASE.

Lubricate until grease purges.

NOTE: Bring engine up to operating temperature

before draining oil.

10. STARTER.

(a) Check oil level daily. For accurate readings, wait

Remove starter for lubrication every 24, 000 miles or 24

at least one minute after engine shutdown for

months, whichever occurs first (Refer to TM 9-2320-283-

checking oil level. If on or below LOW mark, add 2

20).

quarts and recheck.

Remove three socket head screws (See View 0) and add

CAUTION: Oil filter leaks will develop if the

three to five drops of OE/HDO-30 oil to each reservoir

filters are not properly tighten- ed.

The

and lubricate the bushing of drive and drive spline.

tightening requirement for the full-flow and

Clean with solvent, then apply a thin coat of graphite

bypass oil filter is one turn after oil filter gasket

grease (Specification GAA) so the pinion will move

contact. Hand tightening may not be sufficient

freely.

to achieve proper tightness. Therefore, the use

of an oil filter wrench is required to properly

11. TRANSMISSION.

tighten the filters to prevent leaks.

(a) Initial Operation - Change the transmission oil

(b) Change oil, full flow oil filter and bypass filter

and external transmission oil filter after the initial 3,

every 6, 000 miles or 6 month intervals based on

000 miles or 3 months, whichever occurs first.

whichever occurs first.

Discard the external transmission oil filter.

Thereafter, the oil and external filter should be

changed every 24, 000 miles or 12 months,

whichever occurs first.

(1) Clean the mounting surface and app- ly a

light coat of clean lubricating oil to the filter gasket

NOTE: The automatic transmission should be at

surface.

operating temperature when the transmission oil is

drained.

This will ensure quicker and better

(2) Fill both filters with OE/HDO oil or OEA as

drainage.

required at key (See note 19).

Replace the external transmission oil filter and fill the

(3) Tighten the filters until the gaskets contact

transmission through the dipstick opening with 7.80

the filter head surface. Use a filter wrench to

gallons.

tighten the filters one additional turn.

(b) Oil Level Check Procedure:

(d) Check and clean crankcase breather and

attaching hoses whenever oil and filters are

(1) Check the oil while the vehicle is on level

changed.

ground and the parking brake applied. Start the

engine and shift the transmission through all

(e) Capacity:

drive ranges to fill the clutch cavities and oil

passages; then shift to neutral.

TA 236742

CARD 16 of 19