 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 NOTES:
7. DRAINING TRANSMISSION AND
1. FOR OPERATION OF EQUIPMENT IN
CONVERTER. Each 500 hours, when hot, I
PROTRACTED COLD TEMPERATURES
remove transmission drain plug and drain
c o m p l e t e l y . Install transmission drain
prescribed in Key for temperatures above
plug. Remove and clean oil pan. Install
-15F (-26C). Relubricate with lubricants
n e w oil filter. Use new gasket when
specified in Key for temperatures below
replacing oil pan. Install and tighten oil
-15F (-26C). If OEA lubricant is required
pan. Remove converter housing cover
to meet the temperature ranges prescrib-
plate and turn starter ring gear until con-
ed in the Key, OEA lubricant is to be used
in place of OE/HDO-10 lubricant for all
verter plug is accessible. Remove plug
temperature ranges where OE/HDO-10 is
and allow converter to drain completely.
Install converter drain plug and tighten to
specified in the Key.
14 ft pounds. Install housing cover plate.
Fill transmission to low mark. Run engine
2. OIL CAN POINTS. Each 50 hours
at idle speed to fill converter and lines.
clean and lightly coat control linkages,
hinges, and all exposed adjusting threads
With engine running at idle speed, oil at
operating temperature and transmission
with OE/HDO.
in neutral, add oil to bring oil level to
"FULL" mark. Operate for 5 minutes and
3. ENGINE OIL LEVEL HOT OR COLD
check for leaks.
CHECK. Cold engine, oil level should be
at high mark on dipstick. Hot engine, oil
l e v e l must be between high and low
marks on dipstick (allow to set 5 minutes
remove front wheels, clean and inspect
before checking).
all parts, replace damaged or worn parts,
repack bearings and assemble.
4. ENGINE. Oil is to be changed each
9. AIR CLEANER. Replace element each
250 hours. Drain when lubricant is warm.
250 hours. Air cleaner is dry type, no
lubrication is required.
5. ENGINE OIL FILTER. Each 250 hours,
remove filter element, clean housing and
install new filter element. After installing
Each 500 hours,
10. DISTRIBUTOR.
lubricate rotor wick with 1 or 2 drops of
new filter element, fill crankcase, operate
OE/HDO 10. Apply very light coat of GAA
engine for 5 minutes, check housing for
leaks, check crankcase oil level and bring
to breaker cam.
to "FULL" mark.
11. DIFFERENTIAL. Check level each
6. TRANSMISSION AND CONVERTER
250 hours. Change gear lubricant only
when required by maintenance repair ac-
FILL AND LEVEL. Check level each 50
hours with engine running at idle speed,
tion, contamination by water, or other
oil at operating temperature and
foreign material. After refill, operate for
five minutes, check for leaks and bring oil
transmission in neutral. Maintain oil level
level to fill and level plug opening.
at "FULL" mark.
TA 220491
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals