CRANE FAILS LOAD TEST. (Cont) -726250791

TM 9-2320-364-34-1

Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive

electrical circuits a direct short may result. Damage to equipment, injury or death to personnel may

result.

Do not stand under crane. Mechanical

failure and operator error can cause

injury or death to personnel.

Adhesives, solvents, and sealing compounds

can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. To avoid

injury or death, keep away from open fire and

use in well-ventilated area. If adhesives, solvent,

or sealing compound gets on skin or clothing,

wash immediately with soap and water.

Hooked test unit connector must not contact

other transistor wire or damage to

OSS and test unit will result.

VERIFY REPAIR

(1) Set crane main POWER switch to

OFF position.

(2) Set hydraulic selector switch to OFF

position.

(3) Turn OFF engine switch.

(4) Disconnect four connectors from OSS

box.

(5) Install cover on central processor unit

with four screws.

(6) Install safety lock seal on two screws.

(7) Install cover on OSS box with four

screws and preformed packings.

(8) Apply bead of sealant to edge of

cover where it is against OSS box.

(9) Perform load test (Para 16-32).

(a) If crane does not pass load test,

fault not corrected. Notify

supervisor.

(b) If crane passes load test, fault

has been corrected.