 |
|||
|
|
|||
|
Page Title:
ENGINE OVERHEATS (WATER TEMPERATURE GAGE CONTINUOUSLY READS OVER 230F [110C]). (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-34-1
Allow engine to cool before performing
troubleshooting maintenance. If
necessary use insulated pads and gloves.
Hot engine components will burn and cause
injury to personnel.
Do not remove the radiator cap when the
engine is hot; steam and hot coolant can
escape and burn personnel.
Use a clean, thick waste cloth or like
material to remove the cap. Avoid using
gloves. If hot water soaks through gloves,
personnel could be burned.
COOLING SYSTEM PRESSURE TEST
(1) Remove right side noise panel,
(TM 9-2320-364-20).
(2) Remove eight screws, lockwashers,
washers and left side noise panel.
Discard lockwashers.
(3) Remove radiator cap,
(TM 9-2320-364-10).
(4) Install cooling system pressure tester.
(5) Pressurize cooling system to 10 psi
(69 kPa) and check expansion plugs
for leaks.
(a) If expansion plugs are leaking,
replace expansion plugs,
(Para 3-8).
(b) If expansion plugs are not leaking,
expansion plugs are OK.
(6) Release pressure and remove cooling
system pressure tester.
(7) Install radiator cap.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals