 |
|||
|
|
|||
|
Page Title:
P100 3 - OIL PRESSURE CIRCUIT FAILED HIGH (HIGH VOLTAGE) (cont) |
|
||
| ||||||||||
|
|
 TM 9-2320-364-20-1
Section IV. TROUBLESHOOTING CHARTS (Cont.)
E. FLASH CODE:
35
J1587 CODE:
P100 3 - OIL PRESSURE CIRCUIT FAILED HIGH (HIGH VOLTAGE)
STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
35-7
Final Check
Reconnect all connectors.
Code 100/3.
Replace ECM (para 7-57).
Turn ignition on.
Then go to 35-30.
Clear codes.
Start engine (TM 9-2320-364-10).
No codes.
Repairs are complete.
Run for one minute or until
"Check Engine" light comes on.
Any other codes
Go to START-1, pg 2-539, to
Stop engine.
except Code 100/3.
service other codes.
Check active codes.
35-8
Check OPS Connectors
Inspect terminals at OPS
Terminals and
Replace OPS (para 7-68).
connectors (sensor and harness
connectors are okay.
Then go to 35-7.
sides) for damage; bent, corroded
and unseated pins or sockets.
Problem found.
Repair terminals/connectors
(para 7-101). Then go to 35-30.
35-30
Verify Repairs
Turn ignition off.
No codes.
Repairs are complete.
Reconnect all connectors.
Turn ignition on.
Code 100/3 (and
All system diagnostics are
Clear codes.
any other codes).
complete. Please review this
Note status of "Check Engine"
section from the start to find
light.
the error.
If "Check Engine" light does not
stay on, start engine and run
Any other codes
Go to START-1, pg 2-539, to
(TM 9-2320-364-10) until
except Code 100/3.
service other codes.
"Check Engine" light comes on
or engine has run warm (greater
than 60 degrees C, 140 degrees
F) 1 minute.
Read inactive codes.
2-685
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals