ADJUSTMENT (Cont) -699580927

TM 9-2320-363-20-2

NOTE

Prior t o performing step 9, make sure hood is centered so no components will

touch u n d e r hood when hood is lowered.

CLOSE HOOD (1) AND FASTEN TWO HOOD LATCHES (7).

10.

MEASURE GAP BETWEEN HOOD (1) AND COWL (2) 8 IN. (203 mm) BELOW SEAM ON BOTH

SIDES. GAP SHOULD BE 1/2-3/4 IN. (13-19 mm). IF GAP IS INCORRECT, MOVE HOOD (1)

FORWARD OR BACKWARD UNTIL GAP IS CORRECT ON BOTH SIDES.

11.

CHECK SEAMS ON BOTH SIDES OF HOOD (1) AND COWL (2) FOR ALINEMENT. IF SEAMS ARE

NOT ALlNED, NOTE DISTANCE BETWEEN SEAMS.

NOTE

During step 12, be careful not to disturb adjustment from step 10.

12.

TILT HOOD (1) TO FULLY OPEN POSITION.

13.

LOOSEN NUT (5) ENOUGH TO ALLOW INSTALLATION OR REMOVAL OF SHIMS (8), AS

NECESSARY.

14.

INSTALL OR REMOVE ONLY ENOUGH SHIMS (8) TO EITHER RAISE OR LOWER HOOD (1) TO

ALINE SEAMS.

15.

CLOSE HOOD (1) AND REPEAT STEPS 11 THRU 14 UNTIL SEAM IS ALlNED.

4-667