Cleaning/Inspection -726030543

TM 9-2320-360-34-2

(30) Remove two studs (44) from shaft end cover

(37).

(31) Remove two bearings (45) and ring seal (46)

from shaft end cover (37). Discard ring seal.

(32) Remove retaining ring (47) from back of shaft

end cover (37). Discard retaining ring.

(33) Remove seated bearing (48) from shaft end

cover (37). Discard sealed bearing.

(34) Remove seal (49) from shaft end cover (37).

Discard seal.

(35) Remove plug (50) from shaft end cover (37).

b. Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and

clothes, and don't breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138 F (38-59 C). If you become dizzy while using cleaning

solvent, get fresh air immediately and get medical aid. If contact with eyes is

made, wash your eyes with water and get medical aid immediately.

(1) Clean metal parts in dry cleaning solvent.

28-43