 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(23) Install input shaft (9) in input housing (13).
(24) Install output shaft (2) in output housing
(16).
(25) Install four new gasket s (20) and input
housing (13) on output housing (16) with
two screws (21) and nuts (22).
NOTE
Bearings are adjusted by removing
gaskets until bearings bind, then
adding one gasket at a time until
shafts rotate freely and with no end
play.
(26) Remove gaskets (20), one at a time, from
housings (13 and 16) until bearing cones
just bind.
(27) Install gaskets (20), one at a time, on
housings (13 and 16) until shafts (2 and 9)
rotate freely with no end play.
(28) Remove two nuts (22) and separate
housings (13 and 16).
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid Injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
(29) Coat gaskets (20) and housings (13 and
16) with adhesive-sealant (Item 3,
(30) Coat threads of screws (21) with
adhesive-sealant (Item 6, Appendix B).
(31) Assemble gaskets (20) and housings (1 3
and 16) with two nuts (22).
d. Follow-On Maintenance
Fill gear reducer with oil (LO 9-2320-360-12)
27-57 (27-58 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals