 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(10) Position bearing cone (8) small side down
on press.
NOTE
Bearing cone must be pressed on
output shaft until it contacts gear.
(11) Press input shaft (9) into bearing cone (8).
(12) Position bearing cone (10) small side
down on press.
NOTE
Bearing cone must be pressed on
output shaft until it contacts gear.
(13) Press input shaft (9) into bearing cone
(10).
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid Injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
CAUTION
Oil seal must be evenly pressed into
housing.
Failure to comply may
result in damage to oil seal.
NOTE
Plug and oil seal must be installed in
places marked during removal.
(14) Coat plug (11) with adhesive-sealant (Item
9, Appendix B).
(15) Install plug (11) and new oil seal (12) in
input housing (13).
(16) Install two bearing cups (14) in inp ut
housing (13).
27-55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals