Click here to make tpub.com your Home Page

Page Title: Assembly
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-360-34-2
c. Assembly
(1) Lubricate new quad ring seal (1) with hydraulic
oil and install in housing (2).
NOTE
Do step (2) if bearing was removed.
Bearing must be pressed in until
flush  with  inside  surface  of
housing.
(2) Install bearing (3) in housing (2).
NOTE
Do steps (3) thru (12) if seals or
actuating shaft were removed.
(3) Position bearing cap (4) in vise with inside
surface up.
CAUTION
Seals must be evenly pressed in
bearing cap. Failure to comply may
result in damage to seals.
NOTE
High-pressure
seals
must
be
installed by pressing from inside of
bearing cap to outside.
Backup washer must be installed
on all steering gears.
(4) Install new backup washer (4.1) and new high-
pressure seal (5) in bearing cap (4) until it rests
against shoulder.
(5) Lubricate high-pressure seal (5) with hydraulic
oil.
(6) Press actuating shaft (6) into bearing cap (4).
NOTE
Bearing retainer should be tightened
securely to prevent actuating shaft
end play.
(7) Install bearing retainer (7) on bearing cap (4).
(8) Install new retaining pin (8) in bearing cap (4).
Change 1 27-27

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business