 |
|||
|
|
|||
|
Page Title:
Front Housing Disassembly (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(18) Remove bearing (35) and spacer (36)
from shaft (37).
(19) Remove cylinder block (38) and three pins
(39) from shaft (37).
(20) Remove shoe plate (40), nine pistons
(41), and spherical washer (42) from
cylinder block (38).
(21) Remove pin retainer (43) from cylinder
block (38).
WARNING
Cylinder block spring must be held
by screw, washers, and nut before
removing retaining ring. Spring and
retaining ring are under high tension
and can act as projectiles when
released.
Failure to comply may
result in injury to personnel.
CAUTION
Do not clamp on flat surface of
cylinder block.
Failure to comply
may result in damage to machined
surface.
(22) Position cylinder block (38) in soft-Jawed
vise.
(23) Install four washers (44), screw (45), and
nut (46) through cylinder block (38).
(24) Tighten nut (46) and remove retaining ring
(47).
(25) Loosen nut (46) to relieve spring tension.
(26) Remove nut (46), screw (45), and four
washers (44) from cylinder block (38).
(27) Remove spring washer (48), spring (49),
and spring washer (50) from cylinder block
(38).
27-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals