 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(48) Rotate carrier housing (34) so pinion shaft
(56) is pointing down.
NOTE
Backlash should be
0.0100.013
in.(025-0.33 mm).
(49) Check backlash of differential (64) to
pinion shaft (56).
(50) Hold pinion shaft (56) so pinion gear (65)
does not move.
NOTE
Do not allow pinion gear to turn while
doing steps (51) thru (53).
(51) Turn differential (64) counterclockwise
until it stops to take up backlash.
NOTE
Shaft from dial indicator must be at
right (900) angle to face of tooth
when in contact.
(52) Install dial indicator (66) on face of
differential gear tooth (67).
(53) Turn differential (64) clockwise until it
stops.
(54) Record differential (64) to pinion shaft (56)
backlash measured on dial indicator (66).
(55) Remove screw (68) and nut lock plate (69)
from bearing cap (70).
(56) Remove four screws (71) from bearing
caps (70).
(57) Remove two bearing caps (70) from
carrier housing (34).
(58) Remove
adjusting
nut
(72)
from
differential (64).
(59) Install crowbar (73) through differential
(64).
(60) Install strap on crowbar (73).
WARNING
Differential Is heavy and requires the
aid of assistant to move or lift It.
Failure to use caution may result In
Injury to personnel.
(61) Remove differential (64) from
carrier
housing (34) with aid of assistant.
(62) Remove crowbar (73) and strap.
25-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals