 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
24-2. AXLE NO. 1 DIFFERENTIAL REPAIR (CONT)
NOTE
If installing new gear set, record size
of pinion gear (engraved on pinion
end). Compare dimension with new
gear set. If new size is larger, pinion
gear shims will be thinner.
(2) Coat bearings (3 and 4) with lubricating
oil.
(3) Press taper bearing (3) on pinion shaft (5)
using pinion bearing cone installer (5.1).
(3.1) Install shim (6) over end of pinion shaft
(5).
NOTE
If small shim thickness is increased
or decreased, large shim must be
changed accordingly.
(4) Install shim (7) and taper race (8) in
housing (2) until fully seated.
(5) Install pinion shaft (5) through housing (2).
(6) Install taper race (9) and taper bearing (4)
on pinion shaft (5) while assistant
supports pinion shaft (5).
24-8 Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals