 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(101) Install end play adapter (100) in center
hole (101) of end cap (94).
(102) Turn transfer case (102) over so rear half
(48) faces up.
(103) Lightly tap down on center shaft (26)
through hole (103) in adapter end plate
(47) to seat bearings.
(104) Install dial indicator (67) thr ough hole
(103) in adapter end plate (47).
CAUTION
Do not overtighten end play adapter
screw. Damage to center shaft end
plate may result.
(105) Turn end play adapter
screw
(100)
clockwise until tight.
NOTE
End play must be 0.003-0.006 in.
(0.076-0.15 mm). If end play is less
than 0.003 in. (0.076 mm), shims
must be added. If end play is greater
than 0.006 in. (0.15 mm), shims must
be removed.
(106) Check and record end play measured on
dial indicator (67).
(107) Remove end play adapter (100) from end
cap (94).
(108) Remove dial indicator (67) from adapter
end plate (47).
23-29
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals