 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(21) Position rear cover (1) flange side down.
(22) Install new oil seal (25) with seal lip facing
rear cover (1) using oil seal installer (26)
and driver handle (Item 67, Appendix E)
(27).
(23) Install dust shield (28) in rear cover (1),
flat side first, so rear edge of shield is
flush with surface of rear cover.
(23.1) Coat inner surface of oil seal (25) with
high temperature grease.
(24) Install yoke (29) on output shaft (14).
(25) Coat threads of output shaft (14) and new
retainer nut (30) with lubricating oil.
(26) Install new retainer nut (30) on output
shaft (14). Torque to 600-800 Ib-ft (814-
1085 Nm).
e. Installation
(1) Soak eight friction plates (1) in clean
lubricating oil for at least 2 minutes.
(2) Install nine clutch plates (1 and 2) in
adapter housing (3), starting with steel
plate (2) and alternating with friction plate
(1).
(3) Install rear planetary ring gear (4) in
adapter housing (3).
(4) Install remaining clutch plates starting with
friction plates (1).
Change 1 22-105
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals