 |
|||
|
|
|||
|
Page Title:
Table 22-4. First Clutch Pack Height |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(6) Stack nine steel plates (2) and eight
friction plates (3) on flat surface of suitable
hydraulic press, starting with steel plate
and alternating with friction plate.
(7) Place first clutch piston (4) on top of clutch
plates (2 and 3).
(8) Press evenly on first clutch piston (4) with
100 psi load.
(9) Measure distance from base of clutch
plates (2 and 3) to thrust pad (5).
(10) From Table 22-4, select the proper steel
plate combination to obtain 3.0964-3.0744
in. (78.65-78.09 mm) height (6). Tie
these parts together and tag for
subsequent assembly.
NOTE
There are two thickness' of steel
plates.
(11) Measure thickness of one tang (7) on
each of seven steel plates (2). Thin plates
should measure 0.096-0.103 in. (2.44-
2.62 mm). Thick plates should measure
0.116-0.123 in. (2.95-3.12 mm).
(12) Replace friction plate if thickness is less
than 0.1347 in. (3.421 mm).
(13) Repeat steps (4) thru (10) to recheck first
clutch thickness.
(14) Check friction plate for presence of oil
grooves.
(15) Remove first clutch piston (4), steel plates
(2), and friction plates (3) from press.
Table 22-4. First Clutch Pack Height
PLATE
PLATE
FROM
TO
23047771
23047772
3.1363
3.1230
ADD 3
REMOVE 3
3.1230
3.1097
ADD 2
REMOVE 2
3.1097
3.0964
ADD 1
REMOVE 1
3.0964
3.0744
-
-
3.0744
3.0611
REMOVE 1
ADD 1
3.0611
3.0478
REMOVE 2
ADD 2
3.0478
3.0345
REMOVE 3
ADD 3
Change 3 22-102.1 (22-102.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals