Front Carrier

TM 9-2320-360-34-2

22-16. PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT)

Front Carrier

(1) Coat four roller bearings (1) and eight new

black thrust washers (2) with lubricating

oil.

(2) Install thrust washer (2) on each end of

four pinions (3).

NOTE

Do step (3) only If bushing was

removed.

(3) Position front carrier assembly (4) rear

end up. Install bushing (5).

(4) Install two thrust washers (2), roller

bearing (1), and pinion (3) in front carrier

assembly (4), aligning loading pins with

pin bores in carrier (4).

(5) Press spindles (6) in carrier until both

ends of spindle are equal.

(6) Repeat steps (4) and (5) for other five

pinions.

(7) Remove carrier (4) from press and stake

both ends of spindles (6) in four places.

22-92 Change 3