 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(3) Remove center support anchor screw (5)
and washer (6) from transmission (7).
Discard screw and washer.
WARNING
Wear eye protection and use care
when Installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
Injury.
(4) Remove
retaining
ring
(8)
from
transmission (7).
(5) Install center support lifting bracket (9) into
the seal ring grooves on the center
support hub (10).
NOTE
Center support housing is fitted
to transmission housing with
very little clearance and may bind
if transmission housing is cold.
Heat transmission housing with
heat lamp or warm current of air.
If center support housing starts
upward and begins to bind, tap
center
support
housing
downward and lift again.
(6) Lifting straight up, remove center support
(2) from transmission (7).
(7) Set center support (2) on flat work
surface.
(8) Remove
thrust
washer
(11)
from
transmission (7).
(9) Remove lifting bracket (9) from center
support hub (10).
b. Disassembly
(1) Remove fourth clutch piston (1) from
center support housing (2).
(2) Remove outer seal ring (3) and inner seal
ring (4) from fourth clutch piston (1).
(3) Cut and remove four retaining washers
(5). Discard retaining washers.
(4) Remove clutch ring (6) from fourth clutch
piston (1).
(5) Remove 20 springs (7) from fourth clutch
piston (1).
22-77
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals