FORWARD CLUTCH 'AND TURBINE SHAFT REPAIR

TM 9-2320-360-34-2

22-8. FORWARD CLUTCH 'AND TURBINE SHAFT REPAIR

This task covers

a. Removal

d. Assembly

b. Disassembly

e. Installation

c. Cleaning/Inspection

f. Follow-On Maintenance

Initial Setup:

Equipment Conditions

Tools and Special Tools (Cont)

Torque converter housing removed

Installer and Staking Set, Collector Ring (Item 84,

(para 22-7).

Appendix E)

Main control valve removed (para 22-14).

Press, Hydraulic (Item 116, Appendix E)

Protector, Forward Clutch Piston Inner Seal

(Item 118, Appendix E)

Tools and Special Tools

Tool Kit, Gent Mech (Item 202, Appendix E)

Stock, Shim (Figure C-7, Appendix C)

Caliper Set, Micrometer (Item 15, Appendix E)

Tool, Lifting (Item 198, Appendix E)

Compressor Set, Clutch Spring (Item 22,

Appendix E)

Materials/Parts

Compressor Unit, Air (Item 24, Appendix E)

Compound, Retaining (Item 22, Appendix B)

Alignment Tool, Fifth Clutch (Item 9,

Oil, Lubricating (Item 44, Appendix B)

Appendix E)

Solvent, Dry Cleaning (Item 54, Appendix B)

Fixture, PTO Gear Removal (Item 43,

Tape, Insulation, Electrical (Item 57, Appendix B)

Appendix E)

Rings, Seal (2) (Item 253, Appendix F)

Gage, Depth, Micrometer (Item 48,

Ring, Seal (Item 264, Appendix F)

Appendix E)

Ring, Seal (Item 267, Appendix F)

Goggles, Industrials (Item 57, Appendix E)

Heater, Gun Type (2) (Item 68, Appendix E)

Personnel Required

Two

a. Removal

(1) Turn transmission (1) in stand so that turbine

shaft (2) is pointing up.

(2) Remove turbine shaft (2) and forward clutch

assembly (3) using lifting tool (4).

(3) Remove outer race (5), roller bearing (6), and

inner race (7).

(4) Place forward clutch assembly (3) in clean area.

22-37