TORQUE CONVERTER HOUSING/FRONT SUPPORT REPAIR (CONT) -726030213

TM 9-2320-360-34-2

22-7. TORQUE CONVERTER HOUSING/FRONT SUPPORT REPAIR (CONT)

NOTE

If transmission is mounted in stand,

it may only be possible to Install 7 of

11 washers (16) and screws (17). The

remaining four screws will be

installed

when

transmission

removed from stand.

(13) Install seven new lockwashers (16) and screws

(17) holding torque converter housing (7) to

transmission housing (13). Torque to 67-80 lb-ft

(90-108 N m).

WARNING

Adhesive-sealant can bum easily, can

give off harmful vapors, and is

harmful to skin and clothing. To

avoid Injury or death, keep away from

open fire and use in well-ventilated

area. If adhesive-sealant gets on skin

or clothing, wash immediately with

soap and water.

(14) Apply small amount of silicone adhesive-sealant

to two washers (18) and screws (19).

(15) Remove one pitot collector guide screw (8) and

pull up on other pitot collector guide screw (8);

position washer (18) and screw (19). Tighten

screw until snug.

(16)

Remove other pitot collector guide screw (8)

and position washer (18) and screw (19).

Tighten screw until snug.

(17)

Tighten two screws (19) to 38-48 lb-in. (4.3-5.4

Nm).

f. Follow-On Maintenance

Install torque converter pump (para 22-6).

22-36