TORQUE CONVERTER HOUSING/FRONT SUPPORT REPAIR (CONT) -726030212

TM 9-2320-360-34-2

(4) Turn torque converter housing (7) over so.

support hub (2) faces down.

NOTE

Guide screws are installed in side of

pitot collector with one hole in

center.

(5) Install two guide screws (8) in pitot collector (9).

(6) Position pitot collector (9) on forward clutch

housing (10) with tube under pitot collector ring

(11).

(7) Install lifting eyes (12) and lifting device on

torque converter housing (7).

(8) Position torque converter housing (7) over

transmission housing (13) while assistant

operates lifting device.

(9) Align two pitot collector guide screws (8) with

two small holes in torque converter housing (7)

while assistant operates lifting device.

CAUTION

Take care not to damage pitot tube

and seal rings when installing torque

converter housing.

(10) Install torque converter

housing

(7)

transmission housing (13).

(11)

Remove lifting device and lifting eyes (12).

NOTE

Move pitot collector guide screws up

and down to check that pitot tube is

free.

(12) Install seven new lockwashers (14) and screws

(15). Torque to 67-80 lb-ft (90-108 Nm)

22-35