WATER PUMP REPAIR (Cont.) -726030175

TM 9-2320-360-34-2

c. Assembly

NOTE

Do steps (1) thru (3) if bearings

were

removed

during

disassembly.

Bearings

are

installed

with

numbered side of one bearing

facing numbered side of other

bearing.

(1) Lubricate bearings (1 and 2) and shaft (3)

with oil.

CAUTION

Apply pressure to inside bearing

races only. Failure to comply may

damage bearings.

(2) Press shaft (3), threaded end down, into

small bearing (2) using water pump drive

gear installer (4) to support bearing.

(3) Press shaft (3), threaded end up, into

large bearing (1) using water pump drive

gear installer (4) to support bearing.

(4) Place water pump (5) gear-side down on

clean work surface.

(5) Install new oil seal (6), lip facing down, in

water pump (5) using oil seat Installer (7)

and drive handle (8).

WARNING

Adhesive-sealant can burn easily, can give off harmful vapors, and Is harmful to

skin and clothing. To avoid Injury or death, keep away from open fire and use In

well-ventilated area.

If adhesive-sealant gets on skin or clothing, wash

Immediately with soap and water.

(6) Coat outside of new water seal (9) with

adhesive-sealant.

(7) Position new water seal, (9), small side

facing up, in water pump ,(5).

CAUTION

Water pump seal installer must be

used to install water seal to correct

height. Failure to comply may result

in damage to equipment.

NOTE

Excess sealant should be wiped from

water seal.

(8) Install new water seal (9) in water pump

(5) using water pump seal installer (10).

21-5