 |
|||
|
|
|||
|
Page Title:
CAM FOLLOWER AND PUSH ROD REPAIR |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
19-11. CAM FOLLOWER AND PUSH ROD REPAIR
This task covers:
a. Removal
c. Installation
b. Cleaning/Inspection
INITIAL SETUP:
Equipment Conditions
Materials/Parts
Cylinder head on clean work surface.
Oil, Lubricating (Item 45, Appendix B)
Solvent, Dry Cleaning (Item 54, Appendix B)
Tags, Identification (Item 56, Appendix B)
Tools and Special Tools
Tool Kit, Genl Mech (Item 202, Appendix E)
Lockwashers (2) (Item 118, Appendix F)
Blocks, Wooden (Figure C-3, Appendix C)
Caps, Vise Jaw (Item 17, Appendix E)
Dial Indicator, Magnetic (Item 32, Appendix E)
Gage, Feeler (Item 50, Appendix E)
Vise, Machinist's (Item 207, Appendix E)
Wrench, Torque, 0-300 Lb-In. (Item 235,
a. Removal
(1) Remove exhaust valve bridges (1) from
bridge guides (2).
NOTE
Tag cam follower and associated
parts so they may be installed in
original location.
Cam followers are replaced the
same way. Only one is shown.
(2) Set cylinder head (3) on side on 1 in. (25
mm) wooden blocks.
(3) Remove two screws (4) and lockwashers
(5) from cam follower guide (6). Discard
(4) Remove cam follower guide (6) from
cylinder head (3).
(5) Remove cam follower (7) and push rod
assembly (8) from cylinder head (3) as
one unit.
(6) Remove cam follower (7) from push rod
assembly (8).
19-96
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals