PISTON, CONNECTING ROD, AND LINER REPAIR (cont.) -726030109

TM 9-2320-360-34-2

19-10. PISTON, CONNECTING ROD, AND LINER REPAIR (CONT)

(19) Install cap (18) and new bearing shell (19)

over two studs (21).

(20) Install two nuts (17) on two studs (21).

Torque to 60-70 lb-ft (81-95 Nm).

NOTE

Hold down clamps are installed over

each piston and liner.

(21) Install hold down clamp (8) over cylinder

liner (4) with two screws (9).

(22) Repeat steps (5) thru (21) for remaining

pistons (12) and liners (4).

(23) After all liners and pistons have been

installed, remove screws (9) and hold

down clamps (8).

(24) Check that clearance between each

connecting rod attached to same

crankshaft journal is 0.008-0.016 in. (0.2-

0.4 mm) using feeler gage (22).

19-94