|
| |
TM 9-2320-360-34-1
15-4. LONGITUDINAL TORQUE ROD REPLACEMENT (CONT)
(2)
Remove two locknuts (5) and screws (6) from
longitudinal torque rod (4) and axle housing (7).
Discard locknuts.
NOTE
· Spacers are found on end of
longitudinal torque rod connected to
crossmember. Number of spacers
may vary.
· Front of differential can be supported
with floor jack to aid in removal or
installation of spacers.
(3)
Remove
two
locknuts
(8),
screws
(9),
longitudinal torque rod (4), bracket (10), and
spacers (11) from crossmember (12). Discard
locknuts and spacers.
b. Installation
CAUTION
Install same number of spacers as
removed. Failure to do so will
change driveline angle resulting in
equipment damage.
(1)
Install spacers (1), bracket (2), and longitudinal
torque rod (3) to crossmember (4) with two
screws (5) and new locknuts (6). Do not tighten
locknuts.
(2)
Install longitudinal torque rod (3) on axle housing
(7) with two screws (8) and new locknuts (9).
Torque to 212 lb-ft (287 Nm).
(3)
Tighten locknuts (6) to 212 lb-ft (287 Nm).
15-16
|
