|
| |
TM 9-2320-360-34-1
NOTE
Table 2-10 shows which injector is associated with each of the SIDS.
Table 2-10. Injector Identification
FIRING
SIDS
ORDER
CYLINDER
S001
1
3Right
S002
2
3Left
S003
3
4Riqht
S004
4
4Left
S005
5
2Right
S006
6
2Left
S007
7
1 Right
S008
8
1 Left
INJECTOR TEST
(1) Turn ENGINE switch to OFF.
(2) Disconnect injector drive line (wire no. 611 thru 618 depending on cylinder) from injector identified by SID.
(3) Disconnect injector drive line and return line from a nearby injector that is operating properly.
(4) Remove injectors (para 4-2) from cylinder identified by SID and from cylinder in which drive line and
return line were disconnected.
(5) Swap injectors. (Install injector (para 4-2) identified by SID in cylinder that was firing properly. Install
injector that was operating properly in cylinder that was misfiring.)
(6) Clear codes on DDR.
(7) Start engine (TM 9-2320-360-10) and warm to normal operating temperature or until CHECK ENGINE
indicator lights.
(8) Stop engine (TM 9-2320-360-10).
(9) Read inactive codes on DDR.
INJECTOR HARNESS TEST
(1) Turn ENGINE switch OFF.
(2) Replace injector harness (para 4-3).
(3) Reconnect all connectors.
(4) Clear codes on DDR.
(5) Check INJ RESP TIMES and ACTIVE
CODES.
(6) Stop engine (TM 9-2320-360-10).
Change 3 2-62.17
|
