|
| |
TM 9-2320-356-BD
7.
If the pipe sleeve is a little larger, use screwdrivers or wedges (small rocks,
sticks, etc) to keep the pipe sleeve centered on the drive line.
CAUTION
Drive line will warp if a large amout of heat is
applied in one area.
Weld in l/2-inch passes on
opposite sides.
8.
Gas weld or arc weld the pipe to the drive line in l/2-inch passes.
9.
Install drive line in vehicle.
10. Record the BDAR action taken.
When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
10-9/(10-10 blank)
|
