Boost Pressure Sensor - Remove and Install

100

TM 9-2320-312-24-2

Truck Engine

Disassembly and Assembly Section

NOTICE

Care must be taken to ensure that fluids are contained

during performance of inspection, maintenance, test-

ing, adjusting and repair of the product. Be prepared to

collect the fluid with suitable containers before open-

ing any compartment or disassembling any compo-

nent containing fluids.

Refer to Special Publication, NENG2500, "Caterpillar

Tools and Shop Products Guide" for tools and supplies

suitable to collect and contain fluids on Caterpillar

products.

Dispose of all fluids according to local regulations and

mandates.

g00771142

Illustration 251

(1) Speed/timing sensors

(2) Bolt

(3) Electrical connections for speed/timing sensors

1. Position speed/timing sensors (1) on the engine.

Note: Ensure that the speed/timing sensors are

seated on the sensor flanges before you tighten the

bolt on the bracket.

2. Install bolt (2) that fastens the speed/timing

sensors on the engine.

3. Connect plugs (3) for speed/timing sensors (1).

g00771041

i01481057

Illustration 252

Boost Pressure Sensor -

(1) Boost pressure sensor

(2) Electrical connection for boost pressure sensor

Remove and Install

1. Disconnect plug (2) for boost pressure sensor

(1).

SMCS Code: 1917-010

2. Remove boost pressure sensor (1).

Removal Procedure

Installation Procedure

NOTICE

Keep all parts clean from contaminants.

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

Contaminants may cause rapid wear and shortened

component life.