The PTO Configuration Is Set To Cab Switches

352

TM 9-2320-312-24-2

Troubleshooting Section

Neutral switch

PTO interlocks may also be connected in series with

the PTO on/off switch. The interlocks are intended

Cab accelerator pedal position sensor

to prevent the PTO on/off circuit from activating

unless certain conditions are met.

Cab cruise control set/resume switch

INPUT 2

A remote accelerator pedal position sensor

The input 2 is used for the PTO set/rpm increase

is connected to the input 8 when the "PTO

switch when the "PTO Configuration" is programmed

Configuration" is programmed to "Remote Throttle".

to "Remote Switches" or "Remote Throttle".

Note: The wiring for your particular application may

be slightly different. The circuits for the sensor

INPUT 3

common are used interchangeably by the OEM

The input 3 is used for the PTO resume/rpm

of the vehicle. The following circuits are common

decrease switch when the "PTO Configuration"

within the ECM:

is programmed to "Remote Switches" or "Remote

The "Input Sensor Common 1" is terminal 18.

Throttle".

The "Input Sensor Common 2" is terminal 3.

The PTO Configuration Is Set To Cab Switches.

The "AP Sensor/Switch Sensor Common" is

When the "PTO Configuration" is programmed to

"Cab Switches" and the PTO on/off switch is on, the

terminal 5.

following circuits can be used to interrupt a set rpm:

Cruise control set/resume switch

Service brake pedal position switch 1

Service brake pedal position switch 2

Clutch pedal position switch

Neutral switch

Cruise Control Pause Switch

When the "PTO Configuration" is programmed to

"Cab Switches" and the PTO on/off switch is on,

the cab accelerator pedal position sensor can be

limited to one of the following settings by using the

"PTO Cab Throttle RPM Limit" parameter:

Low idle

PTO Top Engine Limit

Top engine limit

The "PTO Configuration" Is Set To Remote

Switches or Remote Throttle.

When the "PTO Configuration" is programmed to

"Remote Switches" or "Remote Throttle" and the

PTO on/off switch is on, the following circuits are

ignored:

Service brake pedal position switch 1

Service brake pedal position switch 2

Clutch pedal position switch