Results

246

TM 9-2320-312-24-2

Troubleshooting Section

Results:

Yes Proceed to Test Step 4.

Repair: If the preceding codes are logged but

not active and the engine is not running properly,

refer to Troubleshooting, "Troubleshooting without

a Diagnostic Code". If the engine is running

properly at this time, an intermittent condition

may be causing the logged codes. Refer

to Troubleshooting, "Electrical Connectors -

Inspect" for additional information on intermittent

connections. If the problem is not evident and

there were logged open circuit faults or short

circuit faults, perform the following repair:

1. Replace the pin terminals with 9X-3401

Connector Pin terminals.

Replace the socket terminals with 9X-3402

Connector Socket terminals.

2. Do not replace the Sensor or the ECM.

Note: If the sensor has an integral connector the

pin terminals cannot be removed. Only replace the

socket terminal in the wiring harness connector.

STOP.