PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

TM 9-2320-312-24-1

PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

0147 00

PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

AT 90-DEGREE TILT, THIS

SURFACE RESTS ON CRIBBING

6 IN (15.2 CM)

OF CRIBBING

NOTE

Chain that is rigged between rear of cab and rear of tractor is intended to serve as an additional safety sup-

port for cab in 90-degree tilt position. To achieve this, it must be tight.

24.

Check that chain (34) is tight when cab has reached 90-degree tilt position. Verify cab is resting securely on cribbing.

DO NOT remove overhead lift until cab is secure.

If chain not tight, raise cab slightly with overhead lift, decrease chain length, then lower cab onto wood cribbing.

If chain tightens before cab rests on front bumper cribbing, raise cab, increase chain length, then lower cab onto

cribbing.

CAB AT 90-DEGREE TILT

ADJUST SO THAT

CHAIN IS TIGHT

0147 00-10