LINES AND PORTS - TM-9-2320-312-24-10800

TM 9-2320-312-24-1

GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED

0134 00

LINES AND PORTS

To keep dirt from contaminating fluid systems when removing and installing fuel, oil, coolant, and hydraulic lines, per-

form the following steps:

Clean fittings and surrounding area before disconnecting lines.

Cover, cap, plug (Item 6, WP 0165 00) or tape lines and ports after disconnecting lines. When these are not avail-

able, use plastic bags and rubber bands, clean rags (Item 51, WP 0165 00), duct tape (Item 60, WP 0165 00) or

other similar materials to prevent dirt from entering system.

Ensure that new and used parts are clean before installing.

Wait to remove cover, cap, plug or tape from lines and ports until just before installing lines.

FLUID DISPOSAL

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

Dispose of contaminated drained fluids in accordance with the Standard Operating Procedures (SOP) of your unit.

END OF WORK PACKAGE

0134 00-6