|
| |
TM 9-2320-304-14&P
5-250
Direct Support and General Support Maintenance (Cont)
5-43. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
(128) Install rear light bar (172),
two lockwashers (173), and
two nuts (174).
(129) Connect wires to rear light
bar (172).
NOTE
Both clearance lights install the
same. Right side shown.
(130) Install clearance light (175),
two lockwashers (176), and
two nuts (177) to roller
bracket assembly (67).
(131) Connect wires to clearance
light (175).
(132) Connect batteries (TM 9-2320-364-20).
(133) Start engine (TM 9-2320-364-10).
(134) Fully extend hook arm (51) to take
tension off pivot point (Para 2-9).
WARNING
Hook arm weighs 1,100 lbs. (499 kg).
Attach suitable lifting device to prevent
possible injury to personnel.
Make sure hook arm is supported with
lifting device during installation to prevent
possible injury to personnel.
(135) Attach lifting device to hook arm (51).
(136) Make sure hook arm (51) is positioned
fully to left side of truck. Use a pry bar
if needed.
Change 1
|
