|
| |
TM 9-2320-304-14&P
5-214
Direct Support and General Support Maintenance (Cont)
5-40.LOAD HANDLING SYSTEM (LHS) MAIN FRAME CYLINDER REPLACEMENT
(CONT).
b. Installation.
(1) Remove two rubber bumpers (1) and locknuts (2) from compression frame (3). Discard locknut.
(2) Install lube fitting (4) in main frame cylinder (5).
WARNING
Main frame cylinder weighs 325 lbs. (148 kg). Attach suitable lifting device prior to
installation to prevent possible injury to personnel.
(3) Attach lifting device to main frame cylinder (5).
WARNING
Use care when installing retaining rings. Retaining rings are under tension and can act as
projectiles when released causing injury to personnel.
(4) Using lifting device, install barrel end of main frame cylinder (5), pivot pins (6), shim (7), and
retaining ring (8) on compression frame (3).
(5) Remove lifting device from main frame cylinder (5).
|
