|
| |
TM 9-2320-304-14&P
2-20
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
NOTE
If flatrack is not engaged in load locks, raise flatrack slightly and lower again. Flatrack
should set completely and engage load locks.
(22) Inspect that both load locks (13) have engaged and flatrack is completely down on truck.
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(23) Put PTO ENGAGE switch (4) in OFF position. Make sure indicator light (5) goes off.
(24) Turn hydraulic selector switch (6) to OFF position.
WARNING
·
When loaded with FRS, or container the center of gravity is moved up and toward
rear of truck. Extreme caution must be taken when turning and ascending or
descending on a grade. Failure to use extreme caution could result in severe injury
or death to personnel.
·
Maximum side slope when loaded with a FRS or container is 30 percent. Failure to
comply may result in equipment damage or severe injury or death to personnel.
·
Do not reduce tire pressure when loaded with FRS or container. Highway tire
pressure, 60 psi (414 kPa) front and 83 psi (572 kPa) rear, is required at all times
when loaded with FRS or container. Failure to comply could result in damage to
equipment and severe injury or death to personnel.
Change 1
|
