|
| |
TM 9-2320-304-14&P
4-158
Organizational Maintenance Instructions (Cont)
4-30. GENERAL WIRE HARNESS REPAIR (CONT).
WARNING
Tip of removal tool is very sharp. Use
caution when using tool. Failure to comply
may result in injury to personnel.
(c) Insert removal tool into terminal
connector cavity (3) until seated.
(d) Pull wire (4) back through
connector (1) and removal tool.
NOTE
·
Do step (e) only if old terminal is
still attached to wire.
·
Make cut directly behind damaged
terminal.
(e) Cut off terminal (5) and wire
seal (6). Discard terminal and seal.
(2) Assembly.
(a) Insert 1 in. (2.5 cm) of wire (4)
through new wire seal (6).
CAUTION
Strip wire after placing it through seal to
prevent damage to individual wire strands.
(b) Strip end of wire (1) leaving 0.25
in. (0.6 cm) of bare wire.
|
