|
| |
TM 9-2320-304-14&P
2-84.3
Operating Instructions (Cont)
WARNING
·
Do not allow front lift adapter to contact the ground. Failure to comply may result
in the front lift adapter disengaging the LHS hook arm, which could result in
damage to equipment and injury or death to personnel.
·
Front lift adapter and hook weigh 1,750 lbs. (794 kg). Attach suitable lifting device
prior to removal or installation to prevent possible injury to personal.
(9)
Put PTO ENGAGE switch (13) in ON position. Make sure indicator light (14) comes on.
(10)
Turn hydraulic selector switch (15) to AUTO.
(11)
Move joystick (16) to UNLOAD. Hook arm will raise and begin to move rearward. LHS NO
TRANS lamp (17) will illuminate to indicate hook arm is up and load lock has been cleared.
NOTE
The position that LHS and front lift adapter need to be in to access the hook arm retaining
pin will vary, depending on the height of the operator.
(12)
Continue to hold joystick (16) in UNLOAD position until LHS hook arm retaining pin (18) can
be removed. FLA 15 to 16 in. (381 to 406 mm) from ground.
(13)
Release joystick (16).
(14)
Remove lock pin (19), washer (20), and LHS hook arm retaining pin (18) from LHS hook
arm (21) and hook (22).
Change 1
|
